It’s taken roughly 4 months – but the fibreglass cafe racer seat is done.
The seat popped out of the mold fairly easily. Probably about 5 minutes of effort. I then gave the edge a rough trim up with the angle grinder and washed off any PVA release agent. I’ll give it a final trim with a dremel once we work out how to fit the seat to the bike.
Over all, I’m wrapt with the result. No serious air bubbles, just a few rough spots that will sand up easily. The seat seems plenty strong enough. I might give it an official 75kg load rating. 🙂
75kg. – Are you kidding??!!
Then Gaz will not be able to ride that bike 🙂